
WIRELESS Dimmable LED Drivers
RLED18-1ACI Wireless 18w constant current dimming LED driver, suitable for ceiling or cupboard mounting
RLED36-3DCI Wireless three channel (RGB) 36w constant current dimming LED driver, suitable for ceiling or
cupboard mounting
RAPSU48v36w 48v 36w DC power supply for use with the RLED36-3DCI
RLED50-1DCV Wireless 50w constant voltage dimming LED driver, suitable for ceiling or cupboard mounting*
RLED90-3DCV Wireless 90w three channel (RGB) constant voltage dimming LED driver, suitable for ceiling or
cupboard mounting*
*maximum rating assumes 12vdc operation, if 24vdc supply used then maximum load doubles
WIRELESS Curtain, Screen & Blind Controls
RACUB Twin relay motorised curtain/screen/blind controller
RACUB-2L Twin relay motorised curtain/screen/blind controller for use with curtain & blind motors that have neutral
& L1 for open & L2 for close at 240v AC
RACUB-24DC Twin relay motorised curtain/screen/blind controller for use with curtain & blind motors that require
24v DC control
WIRELESS Accessories & Interface Units
RAH-SMART RF hand held remote control with colour display, multi-room capability and room, channel and scene
naming facility
RAH07 4 scenes and off plus master raise and lower, RF hand held remote control
RASOFT PC based software complete with USB to RF interface module
WRA-232 Audio-visual interface for bi-directional RS232 or TCP/IP control of Wired and Wireless Rako systems
RAUSB USB to RAKOM interface for the RASOFT programming software
RAB100 RAKOM RF signal repeater booster unit
RAVFR Volt free contact to RACOM radio interface unit
RAVIR RC5 Infrared to RAKOM radio interface unit
RAPIR Ceiling mount presence sensor with integral daylight sensor
RAIPC Intelligent partition control unit
RLED36-3DCI
RACUB
RAH-SMART
RAB10 0
Comentarios a estos manuales